| Link_State_Control_01 |
Link State Control – Expected signal units/orders |
| SC_01_01 |
To check that the No. 7 terminal equipment enters the correct state on
power-up. |
| SC_01_05 |
To check normal alignment procedure |
|
|
| Link_State_Control_02 |
Link State Control – Unexpected signal units/orders |
| SC_02_01 |
To check that the unexpected signal units/orders are ignored ("Out of
service" state) |
| SC_02_02 |
To check that the unexpected signal units/orders are ignored ("Not
aligned" state) |
|
|
| Transmission_failure_03 |
Transmission Failure |
| SC_03_01 |
Test response to transmission failure – detected by SUERM – when in
"Aligned ready" state |
|
|
| SUERM_check_06 |
SUERM Check |
| SC_06_04 |
To check response to a range of time controlled breaks of Tx or
Rx |
|
|
| AERM_check_07 |
AERM Check |
| SC_07_01 |
To test the AERM on error rates below the normal threshold |
|
|
| Transmission_and_reception_control_Basic_08 |
Transmission Control |
| SC_08_04 |
To ensure correct performance when an MSU with erroneous FIB is
received |
|
|
| Transmission_and_reception_control_PCR_09 |
Transmission PCR |
| SC_09_07 |
To ensure correct performance while RPO is set |
|
|
| Congestion_Control_10 |
Congestion Control |
| SC_10_02 |
To check timer T7 is restarted at the reception of SIB (without
expiring of T6) |
|
|